|
  
|
|
|
|
QS6000 can not scan 6 digit barcodes or needs to be reset Our software's Inventory Barcode defaults to 6 digits. In order to scan 6 digit barcodes, interleave 2 of 5, with the QS6000 Plus, do the following: Make sure scanner is connected properly to the computer. Open the Scanner Manual located on the CD ROM accompanying the scanner. It is an Adobe Acrobat .pdf file. Print page 49, 50, 51 and 66. (note: These are the Manual page numbers, Adobe Acrobat numbers will differ slightly). You can download the manual pages (49, 50, 51 and 66) by clicking here. Compulink recommends that you reset the scanner by downloading the reset manual and make sure all other settings are also correct. You can download the reset manual at the bottom of this page. On page 49 Scan the barcode labeled SET On page 50 Scan the barcode labeled Enable Interleaved 2 of 5 On Page 51 Scan the barcode labeled END On Page 66 Scan the barcode labeled SET On Page 66 Scan the barcode labeled Set Minimum Label Length On Page 66 Scan the barcode labeled 0 (zero) On Page 66 Scan the barcode labeled 6 (six) ( 06 determines the minimum length of the barcode ) On Page 66 Scan the barcode labeled END You should now be able to scan 6 digit , interleaved 2 of 5 Barcodes. If you need to reset the scanner use the manual by clicking here |
|
|
